Some settings can be saved in
People (from the car wash system), etc., on
the windscreen can cause the rain and light
sensor to react less sensitively, later, more slowly
or not at all. Regularly clean the reference surface
of the rain and light sensor and check the wiper
blades for damage ÿ p. 369.
personalization function user accounts and
are changed automatically when you switch user
accounts ÿ p. 39.
Problems and solutions
— Crack in the windshield: The impact of a stone
causes the windshield wipers to perform a wipe
cycle if the rain and light sensor is activated.
The sensor then detects that the reference
surfaces have been reduced and adapts.
Window washer fluid level too low
The control indicator lights up yellow.
Fill the window washer fluid reservoir at the next
available opportunity ÿ p. 319.
Depending on the size of the impact, the activation
behavior of the sensor may change.
To remove traces of wax or polish, it is recommended
Failure in the rain and light sensor
to use a glass cleaning product that contains alcohol.
The control indicator lights up yellow.
The window wiper does not turn on automatically in
case of rain even though the rain and light sensor is
activated.
If the window cleaner finds an obstacle on the
glass, it will try to sweep it away. If the obstacle
continues to block the operation of the window
wiper, it will stop. Remove the obstacle and switch
on the wiper again.
— Switch the ignition off and on again.
— If the fault persists, go to a specialized workshop
do.
Malfunction in the wiper
Rear view mirrors
The control indicator lights up yellow.
The window cleaner doesn't work.
General safety instructions
— Switch the ignition off and on again.
— If the fault persists, go to a specialized workshop
do.
Through the exterior mirrors and the interior mirror,
the driver can observe the vehicles behind and
adapt his driving behavior accordingly.
Abnormal operation of the rain and light sensor
For safe driving it is important that the driver
adjusts the exterior mirrors and the interior mirror
correctly before setting off.
Some examples of possible causes of anomalies and
false interpretations in the reference surface area ÿ
p. 6 of the rain and light sensor:
— Wiper blades in poor condition: The pre
The presence of a film or streaks of water due to
poor condition of the wiper blades can cause the
wiper operation to be prolonged, the wiping
intervals to be considerably shortened or the
wiping to become rapid and continuous.
When looking through the exterior mirrors and the
interior mirror, it is not possible to see the entire area
behind and to the sides of the vehicle. These areas
that are outside the visual field are called blind spots.
Other road users and objects may be in the blind spot.
— Insects: The impact of mosquitoes on the
windshield can cause the wipers to start operating.
WARNING
Adjusting the exterior mirrors and the interior
mirror while driving can distract the driver. This
can lead to accidents and serious injury.
— Traces of salt: In winter, the windscreen wipers
may work longer than normal due to the presence
of traces of salt on the windshield almost
dry.
· Adjust the exterior mirrors and the interior mirror
only when the vehicle is in
had.
3 G 0 0 1 2 7 6 0 A H
— Dirt: The presence of dry dust, wax, protective
films (lotus effect), remains of detergent
117
Rear view mirrors
· When parking, changing lanes, overtaking or
turning, always pay close attention to the
surroundings, as other road users or objects
could also be in the blind spot.
NOTICE
If an automatic anti-glare rearview mirror breaks, electrolytic
fluid may leak out. This liquid attacks plastic surfaces. Therefore,
clean it as soon as possible with a damp sponge, for example.
· Always make sure that the mirrors are adjusted
correctly and that visibility to the rear is not
reduced by ice, snow, fogging or objects.
WARNING
inside mirror
Failure to accurately estimate the distance to vehicles behind
you can lead to accidents and serious injuries.
know.
· Curved mirrors (convex or aspherical) au
they increase the visual field and objects are seen in them
smaller and more distant.
Curved mirrors do not allow calculating with
accurately determine the distance to vehicles behind you,
so its use when changing lanes could cause accidents and
serious injuries.
· Whenever possible, use the interior mirror to
accurately estimate the distance to vehicles
behind you or other objects.
Always make sure you have enough visibility
give back
WARNING
Automatic anti-glare rear view mirrors contain an electrolytic
fluid that could leak out if the mirror breaks.
· If it leaks out, the electrolyte fluid may irritate the
skin, eyes and respiratory organs, especially in
the case of people with asthma or similar
Fig. 106 On the windscreen: automatic anti-dazzling
interior mirror.
diseases. Immediately inhale sufficient fresh air
and exit the vehicle or, if this is not possible,
open all windows and doors.
If the electrolyte liquid comes into contact
with eyes or skin, immediately flush affected area with
plenty of water for at least 15 minutes and seek medical
advice.
· If the liquid comes into contact with shoes or
clothing, rinse them immediately with plenty of
water for at least 15 minutes. Before reusing the
footwear or clothing in question, clean it
thoroughly.
Fig. 107 On the windscreen: manual anti-glare
· If you ingest the electrolyte fluid, rinse your mouth
immediately with plenty of water for at least 15
minutes. Do not induce vomiting unless advised
by a doctor. Bus that immediately medical
assistance.
interior mirror.
118
Visibility
Automatic anti-glare interior mirror
exterior mirrors
With the ignition on, the sensors measure the incidence of light
from behind ÿ fig. 106 1 and ahead 2
.
The interior mirror darkens automatically based on the
measured values.
When the incidence of light on the sensors is hindered or
interrupted, e.g. For example, due to a sun blind or hanging
objects, the automatic dimming interior mirror does not work or
does not work correctly. Also, the use of portable navigation
devices attached to the windshield or near the automatic dimming
interior mirror may affect the operation of the sensors ÿ .
The automatic anti-glare function is deactivated in some
situations, e.g. For example, when reverse gear is engaged.
Fig. 108 On the driver's door: rotary knob for the
exterior mirrors.
The functions of the exterior mirrors on left-hand drive vehicles
are described below. The position corresponds to the exterior
Retrovisor interior antideslumbrante manual
— Basic position: the lever located at the lower edge of the
mirror points forwards, towards the windscreen.
mirror on the driver's side, and the position corresponds to the
exterior mirror on the passenger's side. On right-hand drive
vehicles, it's the other way around.
— To darken the mirror, pull the lever backwards ÿ fig. 107.
— Switch on the ignition.
— Turn the knob located on the driver's door to the desired
symbol ÿ fig. 108.
WARNING
Light from the screen of portable navigation devices can
— Conveniently push the control in the direction of the arrows
to adjust the exterior mirror forward, backward, left or right.
cause the automatic dimming interior mirror to malfunction
and lead to an accident and serious injury.
know.
The abnormal operation of the anti function
The exterior mirrors fold electrically towards the
vehicle ÿ .
Automatic dazzling may mean that it is not possible to use
the interior mirror to accurately gauge the distance to
vehicles behind or to other objects.
The heating of the exterior mirrors is activated. The
heating only works when the ambient temperature is
below +20 °C (+68 °F) and initially it works at full
power. After approx. 2 minutes, heats depending on
the room temperature.
Left exterior mirror adjustment
Right exterior mirror adjustment
Zero position. The outside mirror cannot be
adjusted and all features are disabled.
Activate the functions of the exterior mirrors
The following exterior mirror functions can be activated and
deactivated in the infotainment system in the vehicle settings
menu ÿ p. 36.
3 G 0 0 1 2 7 6 0 A H
119
Rear view mirrors
Synchronized mirror adjustment Synchronized
vehicle is moving faster than approx. 15 km/h (9 mph). or
if the knob is turned from one position to another.
mirror adjustment simultaneously adjusts the right exterior
mirror when the left one is adjusted.
WARNING
If proper care is not taken when folding or unfolding the door
mirrors, injury could result.
— Turn the knob to the position.
— Adjust the left exterior mirror. The right mirror will adjust
simultaneously (synchronously).
· Fold or unfold the exterior mirrors only when there is no
obstacle in their travel area.
— If necessary, correct the right mirror settings: turn the knob to
position and adjust the right mirror.
· When moving the exterior mirrors, be careful not to insert your
fingers between the exterior mirror and its base.
Automatic dimming exterior mirror on the driver's side
NOTICE
The automatic dimming exterior mirror
controlled in conjunction with the automatic anti-glare interior
mirror ÿ p. 118.
· Fold in the exterior mirrors whenever you use an automatic
car wash.
Folding the exterior mirrors after parking
car
· Do not fold or unfold the electrically folding exterior mirrors by
hand, as this may damage the electrical operation of the exterior
mirrors.
When the vehicle is locked or unlocked from the outside, the
exterior mirrors fold in or out automatically. For this, the rotary
knob must be in the position ,
Do not leave the heating of the exterior mirrors on for
,
O .
longer than the necessary time
river. Otherwise it causes unnecessary fuel consumption.
If the rotary control for the electric exterior mirrors is in the
position, the exterior mirrors will remain folded.
In the event of a breakdown, the electric exterior mirrors
can be adjusted mechanically
Saving and activating the setting of the exterior mirror for the
front passenger for reversing
pressing his hand on the edge of the mirror.
— Unlock the vehicle with the key to which you want
assign setting.
Some settings can be saved to user accounts in the
personalization function.
— Engage the electronic parking brake.
CO
zation an
P
d change automatically when switching user accounts
Y
ÿ p. 39.
— Switch on the ignition.
— Put the gear in the neutral position.
— Engage reverse gear.
sun protection
— Adjust the front passenger outside mirror
so that e.g. e.g., I can see the curb well
parasols
pavement.
— Put the gear in the neutral position.
— Switch off the ignition.
— The position set for the mirror is saved and assigned to the key.
Activate the settings of the exterior mirror of the front
passenger for reversing:
— Turn the knob for the exterior mirrors to the
position .
— Engage reverse gear with the ignition on. The right outside
mirror will move to the stored position.
Fig. 109 In the interior lining of the front part of the
roof: sun visor.
The exterior mirror on the front passenger leaves the position
saved for reversing when the
120
Visibility
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
