CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– During transportation, protect torque converter -arrow- from
falling out, e.g. with a wire -A-.
Installing
Assembly is carried out in the reverse order; in this case, note the
specified torques in the relevant gearbox workshop manuals un‐
der »Removing and installing gearbox«.
1.3
Securing engine to assembly stand
Special tools and workshop
equipment required
♦ Lifting tackle - 2024 A-
18
Rep. gr.10 - Removing and installing engine
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
♦ Workshop hoist - VAS 6100-
♦ Engine and gearbox support - VAS 6095-
Conditions
•
Engine with gearbox removed and secured on engine bracket
- T10359- .
– Separate gearbox from engine ⇒ page 15 .
– Attach lifting tackle - 2024 A- as shown and lift from engine
and gearbox jack - VAS 6100- using workshop crane - V.A.G
1383 A- .
Caution
Use securing pins arrows on hooks and locking pins to avoid
damage to engine.
– Secure engine to engine and gearbox support - VAS 6095- .
1.4
Installing engine
Assembly mountings ⇒ page 21 .
Installation is carried out in the reverse order. When installing,
note the following:
Caution
Observe the following points during all installation work, in par‐
ticular in the engine compartment, due to the space limitations:
♦ Route all the various lines and electrical wiring so that they
are in their original positions.
♦ Ensure that there is sufficient clearance to all moving or
hot components.
– Check dowel sleeves for centring engine/gearbox and renew
if damaged.
1. Removing and installing engine
19
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
