CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Align the ignition coils with the connectors -arrows- and attach
all connectors onto ignition coils simultaneously.
– Press ignition coils onto spark plugs by hand with uniform
pressure.
1.5
Removing and installing knock sensor 1
- G61-
Removing
– Pull electrical connector -2- off knock sensor I - G61- .
– Remove coolant pump ⇒ page 251 .
Note
The knock sensor I - G61- is located under the intake manifold
behind the coolant pump.
– Remove bolts of knock sensor I - G61- and remove it.
Installing
– Install in reverse order of removal.
•
Specified torque ⇒ page 562 .
1.6
Removing and installing engine speed
sender - G28-
Removing
– Remove engine cover.
– Open hose clip -2- of air pipe.
– Disconnect electrical connector -arrow-.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation .
– Unscrew and remove bolts -1 and 4- and pull air hose down‐
wards off throttle valve module - J338- .
564
Rep. gr.28 - Ignition system
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Pull air hose -1- off charge air cooler and take air pipe out
downwards.
– Detach electrical connector -1- from engine speed sender -
G28- .
– Undo and remove bolt securing engine speed sender - G28- .
Installing
Install in reverse order of removal, observing the following.
•
Specified torque ⇒ Item 6 (page 562) .
1.7
Test data, spark plugs
Engine code
BZB, CAWA, CAWB, CBFA, CCTA,
CCTB, CGYA, CCZA, CCZB, CCZC,
CCZD, CDAA, CDAB
Firing order
Spark plugs
1-3-4-2
VW/Audi
For part numbers, see ⇒ Electronic
parts catalogue (ETKA)
Electrode gap
Specified torque
Change interval
0.8 mm
25 Nm
⇒ Maintenance ; Booklet ; Service ta‐
bles
1. Repairing ignition system
565
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
