CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
2
Injection system
Assembly overview - air filter ⇒ page 466 .
Removing and installing air filter housing ⇒ page 467 .
Removing and installing air filter element ⇒ page 468 .
Removing and installing air mass meter - G70- ⇒ page 469 .
Assembly overview - intake manifold ⇒ page 469 .
Assembly overview - fuel rail ⇒ page 472 .
Removing and installing intake manifold with fuel rail
⇒ page 473 .
Removing and installing injectors ⇒ page 481 .
Renew Teflon seal on injector ⇒ page 484 .
Clean injectors ⇒ page 485 .
Removing and installing fuel pressure sender - G247-
⇒ page 486 .
Removing and installing throttle valve module - J338-
⇒ page 488 .
Cleaning throttle valve module - J338- ⇒ page 489 .
Assembly overview - high-pressure pump with fuel pressure reg‐
ulating valve - N276- ⇒ page 490 .
Removing and installing high-pressure pump ⇒ page 491 .
2.1
Technical data
Engine code
BZB, CAWA, CAWB, CBFA, CCTA, CCTB, CGYA,
CCZA, CCZB, CCZC, CCZD, CDAA, CDAB
Idling check
1)
rpm
rpm
640 … 800
Idling speed
Governed speed
approx. 6500
1)
If voltage supply to engine control unit drops below 12 volt,
idling speed will be raised incrementally up to 990 rpm. The idling
speed cannot be adjusted.
2.2
Overview of fitting locations
Components A to E are not shown in the exploded view.
460
Rep. gr.24 - Mixture preparation - injection
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
