CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
❑ Moisten with fuel only when installing flange.
13 - Fuel delivery unit
❑ Removing and installing ⇒ page 326
❑ Checking fuel pump ⇒ page 331 .
❑ Removing and installing fuel gauge sender - G- ⇒ page 330
❑ Clean strainer if soiled
14 - Suction-jet pump
15 - Flange with fuel filter
❑ With 6.2 bar pressure relief valve
❑ Removing and installing ⇒ page 326
16 - Locking ring 110 Nm
❑ Ensure firm seating
❑ Remove and install using wrench - T10202- .
3.2
Assembly overview - fuel tank (engine codes CBFA, CCTA, CCTB)
1 - Fuel line
❑ Ensure firm seating
2 - Cap
❑ Renew if damaged
3 - Securing bolt
4 - Tank flap unit
❑ With rubber cup.
❑ Removing and installing
⇒ General body repairs,
exterior; Rep. gr. 55 ;
Tank flap unit; Remov‐
ing and installing fuel
tank flap unit .
5 - Breather line
❑ Clipped onto fuel tank
❑ Ensure firm seating
6 - Vacuum line
❑ Clipped onto fuel tank
❑ Ensure firm seating
7 - Earth connection
❑ To protective plate for
filler neck.
❑ Ensure firm seating
8 - Earth connection
❑ Ensure firm seating
❑ Ensure good contact to
body
9 - Clip
10 - Fuel
❑ Emptying ⇒ page 283
❑ Removing and installing ⇒ page 287
❑ When removing, support using engine and gearbox jack - V.A.G 1383 A- .
282
Rep. gr.20 - Fuel supply system
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
11 - Securing straps
12 - Heat shield
13 - Clamping washer
14 - 25 Nm
❑ Renew
❑ To secure the securing straps for the fuel tank, only bolts with loose washers must be used. If different
bolts are used, the securing straps might twist during tightening. Bolts ⇒ ETKA (Electronic parts cata‐
logue) .
15 - Seal
❑ Renew
❑ When installing, fit dry in fuel tank opening.
❑ Moisten with fuel only when installing flange.
16 - Fuel delivery unit
❑ Removing and installing ⇒ page 326
❑ Checking fuel pump ⇒ page 331 .
❑ Removing and installing fuel gauge sender - G- ⇒ page 330
❑ Clean strainer if soiled
17 - Pop rivet
18 - Protective plate
❑ For filler neck.
19 - Suction-jet pump
20 - Flange with fuel filter
❑ With 6.2 bar pressure relief valve
❑ Removing and installing ⇒ page 326
21 - Locking ring 110 Nm
❑ Ensure firm seating
❑ Remove and install using wrench - T10202- .
3.3
Emptying fuel tank
Special tools and workshop equipment required
♦ Fuel extractor - VAS 5190-
3. Fuel tank (Passat, CC)
283
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
