Download
Table of Contents > Turbocharging/supercharging > Exhaust turbocharger

VW Passat B6 Service Manual ➜ Exhaust turbocharger

CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
21 – Turbocharging/supercharging  
1
Exhaust turbocharger  
Note  
Secure all hose connections with hose clips which conform to  
production standard.  
Hose connections and hoses for charge air system must be  
free of oil and grease before assembly. The seal and sealing  
surface must be oiled lightly only for plug-in connectors  
⇒ page 431 .  
Charge air system must be free of leaks.  
Renew self-locking nuts.  
Hose clip pliers - VAS 6362- or hose clip pliers - V.A.G 1921-  
are recommended for installation of spring-type clips.  
Fill turbocharger with engine oil at oil supply line connection.  
After installing turbocharger, run engine for about 1 minute at  
idling speed and do not rev up immediately. This ensures that  
the turbocharger is fully primed with oil.  
Observe rules for cleanliness ⇒ page 280 .  
Assembly overview - turbocharger ⇒ page 424 .  
Installing hose connections with plug-in connectors  
⇒ page 431 .  
Removing and installing turbocharger ⇒ page 432 .  
Checking turbocharger vacuum unit ⇒ page 438 .  
Removing and installing vacuum unit for turbocharger  
⇒ page 443 .  
Adjusting turbocharger vacuum unit - (engine codes BZB, CGYA,  
CDAA) ⇒ page 439 .  
1.1  
Assembly overview - turbocharger  
424  
Rep. gr.21 - Turbocharging/supercharging  
 

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!