Download
Table of Contents > Assembly mountings > Checking adjustment of assembly mountings (engine and gearbox mountings)

VW Passat B6 Service Manual ➜ Checking adjustment of assembly mountings (engine and gearbox mountings)

CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
❑ 40 Nm + 90° (1/4 turn) further  
12 - Gearbox mounting  
❑ Illustration shows version for dual clutch gearbox.  
13 - Engine support  
14 - Bolts  
❑ Engine support to engine  
❑ Renew  
1
40 Nm + 180° ( / turn further)  
2
2.3  
Checking adjustment of assembly  
mountings (engine and gearbox mount‐  
ings)  
There must be a distance -a- of at least 10 mm between engine  
support and longitudinal member (right side).  
The side surface of the engine support -2- should be located par‐  
allel to the support arm -1-.  
– If the conditions are not met, the assembly mountings must be  
adjusted ⇒ page 21 .  
2.4  
Adjusting assembly mountings (Passat  
2006 ▶, CC)  
Note  
If just the assembly mounting on the engine side is to be adjusted,  
one hook - 10 - 222 A /10- will suffice on the engine side. There  
is also no need to remove air filter, battery and battery carrier.  
24  
Rep. gr.10 - Removing and installing engine  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!