Download
Table of Contents > Electronic power control (EPC) > Removing and installing accelerator pedal module

VW Passat B6 Service Manual ➜ Removing and installing accelerator pedal module

CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
10  
Electronic power control (EPC)  
Assembly overview - accelerator module ⇒ page 390 .  
Removing and installing accelerator module ⇒ page 390 .  
10.1  
Assembly overview - accelerator module  
1 - Connector  
❑ Black, 6-pin.  
2 - Accelerator position sender  
- G79- with accelerator posi‐  
tion sender 2 - G185-  
❑ Not adjustable.  
❑ The accelerator position  
sender passes the posi‐  
tion of the accelerator  
on to the engine control  
unit.  
❑ -A- openings for release  
tool .  
Removing and installing  
3 - 10 Nm  
4 - Cover  
10.2  
Removing and installing accelerator  
pedal module  
Special tools and workshop equipment required  
390  
Rep. gr.20 - Fuel supply system  
   
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
♦ For left-hand drive vehicles: release tool - T10238-  
Or  
♦ For right-hand drive vehicles: release tool - T10240-  
Removing  
– Remove steering column cover -arrows-.  
– Prise out cap -3- using a screwdriver.  
– Remove bolts -2-.  
– Release connector -1- -arrow- and pull off accelerator module.  
10. Electronic power control (EPC)  
391  
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
– Push release tool - T10238- (for right-hand drive vehicles re‐  
lease tool - T10240- ) into intended holes as shown to stop  
and remove accelerator module.  
Note  
In the Tiguan, raise the release tool slightly and then insert it at a  
slight angle.  
Installing  
– Reconnect connector -1- to accelerator module -4-. Lock con‐  
nector -arrow-.  
– Press accelerator module onto securing pins -5-.  
– Insert centring pin -6- into hole in underbody.  
– Secure accelerator module with bolt -2- and install cap -3-.  
– Install steering column trim.  
Specified torque:  
Component  
Nm  
10  
Accelerator module to body  
392  
Rep. gr.20 - Fuel supply system  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!