CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
8
Engine control unit - J623- (Scirocco
to 11/08)
Removing and installing engine control unit with protective hous‐
ing ⇒ page 515 .
8.1
Removing and installing engine control
unit
If you wish to renew the engine control unit, connect the vehicle
diagnostic tester and perform the guided function “Renewing con‐
trol unit”.
Removing
– Switch off ignition.
– Remove wiper arms, ⇒ Electrical system; Rep. gr. 92 ; Wind‐
screen wiper system; Removing and installing wiper arms.
– Remove plenum chamber bulkhead ⇒ General body repairs;
Rep. gr. 50 ; Body - front; Plenum chamber bulkhead .
– Press retaining frame down in -direction of arrow- and remove
engine control unit.
– Push connector locking devices in direction of -arrow-, and pull
connectors off.
Installing
– Fit connectors to engine control unit and slide locking devices
onto stop in direction of -arrow-.
514
Rep. gr.24 - Mixture preparation - injection
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
