CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
10 – Removing and installing engine
1
Removing and installing engine
Special tools and workshop
equipment required
♦ Release lever - 80 - 200-
♦ Lifting tackle - 2024 A-
♦ Engine and gearbox jack - V.A.G 1383 A-
♦ Hose clip pliers - V.A.G 1921- or hose clip pliers - VAS 6362-
♦ Stepladder , commercially available
♦ Engine bung set - VAS 6122-
♦ Drip tray for workshop hoist - VAS 6208-
4
Rep. gr.10 - Removing and installing engine
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
♦ Engine bracket - T10359 A- with pin - T10359/2-
♦ Locking device from gearbox support - 3282-
Disconnecting gearbox from engine and assembling
⇒ page 15 .
Securing engine to assembly stand ⇒ page 18 .
Install engine ⇒ page 19 .
Assembly mountings ⇒ page 21 .
1.1
Removing engine
Note
♦ The battery earth must be disconnected for the remaining pro‐
cedure. Therefore, first check whether a coded radio is fitted.
Then obtain anti-theft coding first if necessary.
♦ The engine is removed downwards together with the gearbox.
♦ All cable ties that are opened or cut through when the engine
is removed must be renewed/replaced in the same position
when the engine is installed.
Caution
Observe the following points during all installation work, in par‐
ticular in the engine compartment, due to the space limitations:
♦ Route all the various lines and electrical wiring so that they
are in their original positions.
♦ Ensure that there is sufficient clearance to all moving or
hot components.
1. Removing and installing engine
5
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
