CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
3
Crankshaft
Tightening sequence - crankshaft ⇒ page 73 .
Removing and installing sender wheel ⇒ page 73 .
Allocation of crankshaft bearing shells ⇒ page 74 .
Pulling needle bearing out of and driving into crankshaft
⇒ page 75 .
Crankshaft dimensions ⇒ page 77 .
Measuring axial clearance of crankshaft ⇒ page 77 .
Measuring radial clearance of crankshaft ⇒ page 78 .
3.1
Assembly overview - crankshaft
Note
Secure engine to repair stand using engine and gearbox support
- VAS 6095- when dismantling/assembling engine ⇒ page 18 .
1 - Cylinder block
❑ If the cylinder block is re‐
newed, the bearing
shells must be realloca‐
ted to cylinder block
⇒ page 74
2 - Bearing shell for cylinder
block
❑ With oil groove.
❑ Do not interchange
used bearing shells
(mark).
❑ Marking of crankshaft
bearing shells
⇒ page 74
3 - Crankshaft
❑ After removing, place it
down so that the sender
wheel -item 5- is not
damaged and the crank‐
shaft does not rest on
the sender wheel
❑ If the crankshaft is re‐
newed, the bearing
shells must be realloca‐
ted to bearing cap
⇒ page 74
❑ Axial clearance
⇒ page 77
❑ Radial clearance
⇒ page 78
❑ Do not rotate crankshaft
when checking radial
clearance
❑ Crankshaft dimensions
⇒ page 77 .
72
Rep. gr.13 - Crankshaft group
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
