CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Place electrical wiring at small coolant pipe to one side
-arrow-.
– Unscrew bolts -2 and 3-.
– Detach small coolant pipe from coolant pump and coolant ho‐
ses -1 and 4-.
Installing
•
Specified torques ⇒ page 261 .
Installation is carried out in the reverse order. When installing,
note the following:
Note
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ EKTA (Electronic parts cata‐
logue) .
– Installing hose connections with plug-in connectors
⇒ page 431 .
2.10
Continued coolant circulation pump - V51- - exploded view
1 - Bracket
2 - Bolt
❑ 40 Nm
3 - Coolant hose
4 - Coolant hose
5 - Continued coolant circula‐
tion pump - V51-
6 - Bracket
7 - Bolt
❑ 8 Nm
2. Coolant pump, thermostat, coolant pipes
267
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
2.11
Removing and installing continued cool‐
ant circulation pump - V51-
Special tools and workshop equipment required
♦ Hose clamps to 25 mm - 3094-
♦ Spring-type clip pliers - VAS 6362-
Removing
Proceed as follows:
WARNING
The cooling system is under pressure when the engine is hot!
Danger of scalding by steam and hot coolant.
Cover filler cap on expansion tank with a cloth and open care‐
fully to release pressure.
– Open filler cap on expansion tank.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation .
268
Rep. gr.19 - Cooling
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
