Table of Contents > Cylinder head, valve gear > Valve gear > Checking valve guides

VW Passat B6 Service Manual ➜ Checking valve guides

CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
Inlet side  
Exhaust side  
If the valve cotters have been removed from the installation  
cartridge, they must first be inserted into the insertion device  
- VAS 5161/18- .  
Press assembly cartridge -VAS 5161/8- onto insertion device  
from above and pick up valve cotters.  
– Press installation cartridge - VAS 5161/8- down with pressure  
fork - VAS 5161/2- , and turn installation cartridge knurled  
screw back and forth whilst pulling upwards.  
– Relieve pressure fork - VAS 5161/2- whilst pulling on knurled  
– Remove removal and installation device for valve cotters -  
VAS 5161- .  
Further assembly is basically a reverse of the dismantling se‐  
quence. During this procedure, observe the following:  
– Install camshafts ⇒ page 185 .  
Checking valve guides  
Special tools and workshop equipment required  
Rep. gr.15 - Cylinder head, valve gear  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.

Ask your question on the page - Support!