CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Remove support for intake manifold (remove nut -2- and bolt
-1-).
Coolant temperature sender - G62- with retaining clip:
– Disconnect electrical connector -1- at coolant temperature
sender - G62- .
– Detach retaining clip (press release tabs -arrows-).
– Pull out coolant temperature sender - G62- .
Note
Insert new coolant temperature sender - G62- , with O-ring, im‐
mediately into union to avoid loss of coolant.
Coolant temperature sender - G62- with retaining plate:
– Disconnect electrical connector -2- at coolant temperature
sender - G62- .
– Unscrew bolts -arrows- and remove retaining plate -1-.
– Pull out coolant temperature sender - G62- .
Note
Insert new coolant temperature sender - G62- , with O-ring, im‐
mediately into union to avoid loss of coolant.
Installing:
Install in reverse order of removal, observing the following.
♦ Renew O-ring.
♦ After completing repair: check coolant level.
2.7
Assembly overview - coolant pipes
2. Coolant pump, thermostat, coolant pipes
261
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
1 - Coolant pipes (front)
2 - Coolant hose
❑ From turbocharger
3 - Coolant hose
❑ To coolant expansion
tank
4 - Bolt
❑ 3.5 Nm
5 - O-ring
❑ Renew
6 - Coolant hose
❑ To heat exchanger for
heater unit.
7 - Small coolant pipe
❑ Removing and installing
⇒ page 265
8 - Bolts
❑ 9 Nm
9 - Coolant hose
10 - Bolt
❑ 5 Nm
11 - Coolant hose
❑ From continued coolant
circulation pump - V51- .
12 - Coolant hose
❑ To continued coolant
circulation pump - V51- .
2.8
Removing and installing front coolant
pipes
Special tools and workshop equipment required
♦ Spring-type clip pliers - VAS 6362-
262
Rep. gr.19 - Cooling
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
