CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
Pay attention to installation position of turbocharger air recircula‐
tion valve - N249-
2.3
Assembly overview - air filter
1 - Spring-type clip
2 - Air intake hose
❑ To turbocharger
❑ Check air hose for con‐
tamination and leaves
3 - Air mass meter - G70-
❑ Removing and installing
⇒ page 469
4 - Bolts
❑ 1.5 Nm
❑ For upper part of air fil‐
ter.
5 - Bolts
❑ 1.5 Nm
❑ For upper part of air fil‐
ter.
6 - Air filter upper part
❑ Clean any salt residue,
leaves and dirt from up‐
per part of air filter
7 - Filter element
❑ Always use genuine
part for air filter element
❑ Removing and installing
⇒ page 468
❑ Observe change inter‐
vals ⇒ Maintenance ;
Booklet ; Service tables
8 - Bolt
❑ 8 Nm
❑ For air filter lower part
9 - Snow screen
❑ Not fitted in all vehicles.
10 - Air filter lower part
❑ Clean any salt residue, leaves and dirt from lower part of air filter.
11 - Connection for water drain hose
❑ Clean connection
466
Rep. gr.24 - Mixture preparation - injection
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
12 - Water drain hose
❑ Clean water drain hose
13 - Flutter valve
14 - Intake air guide
❑ To lock carrier.
❑ Clean any leaves and dirt out of intake air duct
2.4
Removing and installing air filter hous‐
ing
Removing:
Proceed as follows:
– Pull cover off air duct (release clips on sides) -arrows-.
– Release clips -arrows- air duct at the bottom and remove duct.
– Detach air duct at bottom together with air hose.
Engine code CBFA:
– Pull hose to secondary air pump motor - V101- from air filter
housing.
All:
– Pull off connector -1- from air mass meter - G70- .
– Remove hose clips -2- and -3- and remove connecting pipe.
– Remove bolt -4- and pull air filter housing upwards out of
mounting.
Installing:
Install in reverse order of removal.
2. Injection system
467