Passat 2011 ➤ , Passat Variant 2011 ➤
Maintenance - Edition 01.2019
4.31
Multi-purpose additive for petrol fuel:
adding
4.31.1
Specification for using multi-purpose ad‐
ditive for petrol fuel
Note
♦ In the three markets mentioned below there is a particularly
high risk of deposits forming on the injectors and inlet valves
owing to the quality of the fuel.
♦ To counteract the formation of deposits, a multi-purpose ad‐
ditive for petrol fuel must be added.
♦ Only additives compliant with VW 507 53 B (multi-purpose ad‐
ditive G 001 780 M3) may be used.
♦ Observe the dosing instructions on the additive container.
♦ After adding the additive, it is extremely important to fully refuel
the vehicle to achieve optimal effectiveness of the additive.
– Fill multi-purpose additive for petrol fuels into regular fuel tank
during each oil change service.
Country
China
India
Russia
4.31.2
Recommendation for using multi-pur‐
pose additive for petrol fuel
Note
♦ In the following markets with a high risk of coke and deposit
formation, the addition of a multi-purpose additive is recom‐
mended owing to the elevated olefin content and aromatics in
the petrol.
♦ Only additives compliant with VW 507 53 B (multi-purpose ad‐
ditive G 001 780 M3) may be used.
♦ Observe the dosing instructions on the additive container.
♦ After adding the additive, it is extremely important to fully refuel
the vehicle to achieve optimal effectiveness of the additive.
♦ The multi-purpose additive can also be used in all other mar‐
kets that are not listed in the table.
– Fill multi-purpose additive for petrol fuels into regular fuel tank
during each oil change service.
Country
Algeria
Bahrain
Bolivia
Brazil
Mauritius
Niger
Nigeria
Oman
Ghana
Pakistan
104
4. Descriptions of work:
Passat 2011 ➤ , Passat Variant 2011 ➤
Maintenance - Edition 01.2019
Country
Peru
Indonesia
Iraq
Iran
Philippines
Saudi Arabia
Senegal
Japan
Yemen
Jordan
Cambodia
Qatar
Singapore
Surinam
Syria
Chad
Columbia
Kuwait
Lebanon
Malaysia
Uzbekistan
United Arab Emirates
Vietnam
4.32
Memory seat: initialising
All memories and settings will be cleared during the initialisation
process. The memory buttons can then be reprogrammed and
resynchronised with a remote control key.
– Open driver door.
– Move seat and seat backrest forwards to stop.
– When the seat backrest is fully forwards, release switch and
press again until a gong sounds after a few seconds.
4.33
Engine and components in engine com‐
partment: inspecting for leaks and dam‐
age (from above and below)
– Remove engine cover panel, if necessary ⇒ page 106 :
– If necessary, remove engine cover panel (noise insulation) -
bottom- ⇒ page 109 .
Inspect as follows:
– Check engine and components in engine compartment for
leaks and damage.
– Lines, hoses and connections
♦ Fuel system
♦ Cooling and heating system
♦ Lubrication system
♦ Air conditioning system
♦ Intake system
♦ And brake system
Check for leaks, abrasion, porousness, cracks, correct seating
and attachment in retainers.
4. Descriptions of work:
105
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
