Download
Table of Contents > Descriptions of work > Interior and exterior body: inspecting for corrosion with doors and flaps open

VW Passat B7 Service Manual ➜ Interior and exterior body: inspecting for corrosion with doors and flaps open

Passat 2011 ➤ , Passat Variant 2011 ➤  
Maintenance - Edition 01.2019  
4.24  
Interior and exterior body: inspecting for  
corrosion with doors and flaps open  
Test locations  
♦ Sliding roof frame  
♦ Inner and outer door frame  
♦ Area around trim strips  
♦ Windscreen roof edge  
♦ Outer and inner A-pillar  
♦ Bonnet  
♦ Wheel arches  
♦ Inner and outer tailgate  
4.25  
Poly V-belt: renewing  
Procedure  
⇒ Rep. gr. 13 ; Cylinder block belt pulley end; Removing and  
installing poly V-belt  
Note  
For technical reasons it is possible that several cross references  
are not directed to the correct chapter. In this case select the pro‐  
cedure manually in the information.  
4.26  
Poly V-belt: check condition  
Carry out following procedure:  
– Remove “bottom” engine compartment cover (noise insula‐  
tion) ⇒ page 109 .  
– Use a suitable socket to turn the engine at the vibration damp‐  
er/belt pulley.  
4. Descriptions of work:  
93  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!