Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
3.3
Entries in service schedule
If a component is changed which has a change interval prescri‐
bed by the manufacturer, e.g. the toothed belt, the new change
interval begins at the time the component is changed.
•
Therefore it is very important, every time a component is
changed, to document this in the service schedule.
•
This also applies to components which were changed before
the regular change interval.
3.4
Connecting vehicle diagnostic tester
Special tools and workshop equipment required
♦ Diagnosis system -VAS 6160 A-
♦ Diagnosis system VCI -VAS 6150 C-
Note
Ensure that the selected vehicle diagnostic tester is used only
with the respective diagnostic cable.
NOTICE
During a road test, always secure testing and measuring
equipment on the back seat.
Only a passenger may operate these devices while the vehi‐
cle is in motion.
30
3. General information
Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
Sequence of operations
– Connect diagnostic line connector to diagnostic connection.
– Switch on vehicle diagnostic tester.
– Switch on ignition.
Now follow instructions on screen in order to start desired func‐
tions.
3.5
Vehicle identification number
♦ Vehicle identification number on extension of longitudinal
member ⇒ page 31
♦ Significance of vehicle identification number ⇒ page 32
3.5.1
Vehicle identification number on lower
edge of windscreen
The vehicle identification number (chassis number) -arrow- is
located on the left-hand side of the vehicle in the windscreen
near the wiper mounting. It is visible from the outside.
3.5.2
Vehicle identification number on exten‐
sion of longitudinal member
The vehicle identification number is located on the extension of
longitudinal member -arrow-.
3. General information
31