Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
– Pour about 0.5 litre of tap water into the water drain from
a measuring beaker using a commercially available funnel.
Proceed with caution to make sure no water enters the vehi‐
cle interior.
– Check under vehicle if water emerges in area of rear wheel
housing.
– Repeat procedure on other side of vehicle.
– If no water emerges at relevant positions, clean sunroof
drains.
Note
Cleaning of the sliding sunroof drains is a repair measure which
is subject to a separate charge when performed.
4.58
Sliding sunroof drains at front (Passat
estate): check for blockage, clean if
necessary
Open sliding sunroof completely.
– Check water drain at front -arrows- for contamination, and
clean if necessary.
– Pour about 0.5 l of tap water from a measuring beaker into
the front water drain. Proceed with caution to make sure no
water enters the vehicle interior.
– Check under vehicle if water emerges in area of front wheel
housing.
– Repeat procedure on other side of vehicle.
– If no water emerges at relevant positions, clean sunroof
drains.
Note
Cleaning of the sliding sunroof drains is a repair measure which
is subject to a separate charge when performed.
184
4. Descriptions of work
Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
4.59
Service interval display: resetting
Resetting service interval display using vehicle diagnostic tester
Resetting service interval display without vehicle diagnostic
tester ⇒ page 185
Additional information for service interval display ⇒ page 8
A reset of the service interval display during
♦ delivery inspection
♦ each oil change (flexible/fixed)
is carried out!
Note
It is also possible to reset the service interval display (SID)
manually. However, bear in mind that, on vehicles coded to
flexible interval, the SID needs to be coded to fixed intervals.
This also modifies the adaptation channel for oil quality.
4.59.1
Service interval display: resetting using
vehicle diagnostic tester
– Reset service interval display ⇒ page 30 .
– Select the respective service which is to be reset.
4.59.2
Service interval display: resetting with‐
out vehicle diagnostic tester
Oil change service interval display: resetting
Function button on dash panel insert:
– With ignition switched off, press and hold button -1-.
– Switch on ignition.
Wait until “Reset oil change service?” appears on the display.
on the display.
– Release button -1-.
The service interval display is now in the resetting mode.
– Briefly press button -1- once.
After a short time the display switches back to the original dis‐
play.
4. Descriptions of work
185