Download
Table of Contents > Descriptions of work > Tyre pressure indicator: calibrating

VW Passat B8 Service Manual ➜ Tyre pressure indicator: calibrating

Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤  
Maintenance - Edition 11.2020  
Reducing agent (AdBlue®/DEF):  
changing  
4.47  
Sequence of operations  
– ⇒ 4-cylinder common rail (2.0 l, 4V, bi-turbocharger); Rep.  
gr. 26; SCR system (Selective Catalytic Reduction)  
4.48  
Tyre pressure indicator: calibrating  
Note  
The calibration of the Tyre Pressure Loss Indicator must on‐  
ly be performed “after” the tyre pressure has been corrected  
to the prescribed values.  
If no pressure loss and tyre damage are found after a tyre  
pressure warning, the incorrect warning can be rectified by  
calibrating.  
Tyre Pressure Loss Indicator compares the speed and thus  
the rolling circumference and vibrations of the individual wheels  
via the ABS sensors. If the tyre pressure changes on one or  
several wheels, the Tyre Pressure Loss Indicator will indicate  
this in the dash panel insert and the Infotainment system.  
The rolling circumference of tyre changes if:  
♦ The tyre pressure is too low.  
♦ The tyre has structural damage.  
♦ The vehicle is loaded more heavily on one side.  
♦ The wheels on one axle are loaded more heavily (e.g. when  
towing a trailer or when driving in mountains).  
♦ Snow chains are fitted.  
♦ The temporary spare wheel is fitted.  
♦ One wheel per axle has been changed.  
The tyre pressure monitoring warning lamp has a yellow warn‐  
ing lamp in the dash panel insert -arrow-.  
♦ A “PERMANENT LIGHTING-UP” in conjunction with a warn‐  
ing tone, means “WARNING”, pressure loss has been detec‐  
ted, check tyre pressure and carry out calibration.  
Calibration:  
– Switch on ignition.  
– Switch on Infotainment system.  
152  
4. Descriptions of work  
Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤  
Maintenance - Edition 11.2020  
– Press Infotainment button CAR .  
– Press Setup function button.  
– Press Tyres function button.  
– Press Set function button.  
– Press Confirm function button.  
4.49  
Tyre repair set: Checking  
Note  
Depending on the equipment level, the vehicles are equip‐  
ped with a breakdown set.  
It also contains a filling bottle with tyre sealant.  
The breakdown set is in the spare wheel well in the luggage  
compartment.  
The breakdown set includes a bottle of tyre sealant -2- and a  
compressor -1-.  
The tyre sealant in the bottle has a limited shelf life.  
The expiry date is therefore specified on the bottle -2-.  
– Enter expiry date in maintenance table.  
– If the expiry date has been reached, replace tyre sealant.  
(The tyre sealant must not be more than 4 years old).  
4.50  
Window wash/wipe system and head‐  
light washer system: checking function  
Checking anti-freeze protection of fluid, topping up fluid ⇒ page  
Window wash/wipe system: check spray jet settings and adjust  
if necessary ⇒ page 155  
Headlight washer system: checking spray jet settings ⇒ page  
156  
Windscreen wiper blades: check park position ⇒ page 157 .  
Rear window wiper blades: checking park position ⇒ page 157  
4.50.1  
Anti-freeze: checking protection of flu‐  
id, topping up fluid if necessary  
Special tools and workshop equipment required  
♦ Refractometer -T10007A-  
4. Descriptions of work  
153  
 

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!