Download
Table of Contents > Descriptions of work > Camshaft drive toothed belt (diesel engines): renewing

VW Passat B8 Service Manual ➜ Camshaft drive toothed belt (diesel engines): renewing

Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤  
Maintenance - Edition 11.2020  
Note  
During oil change service or inspection, only warning stick‐  
ers that are attached in visible areas are checked.  
Missing warning stickers on high-voltage components must  
be renewed.  
– Check warning sticker ⇒ 4-cyl. direct injection (1.4 l engine,  
4V, EA 211, turbocharger, hybrid); Rep. gr. 93; Warning  
sticker; Checking warning sticker.  
4.68  
Water drain valves at rear (Passat es‐  
tate): check for blockages, clean if nec‐  
essary  
– Detach wheel housing liner at rear left -1- sufficiently to gain  
access to water drain valve -2-.  
– Open rear water drain valve, check it for damage, and re‐  
move any blockages.  
– Repeat procedure on other side of vehicle.  
4.69  
Toothed belt (petrol engines): renewing  
Camshaft drive toothed belt: renewing, petrol engines  
– ⇒ 4-cylinder injection engine (1.4 l direct injection engine,  
turbocharger); Rep. gr. 15; Toothed belt drive; Removing  
and installing toothed belt  
Coolant pump toothed belt: renewing, petrol engines  
– ⇒ 4-cyl. injection engine (1.4 l direct injection engine, turbo‐  
charger); Rep. gr. 19; Coolant pump/thermostat assembly  
4.70  
Camshaft drive toothed belt (diesel en‐  
gines): renewing  
TDI common rail engines:  
– ⇒ Rep. gr. 15; Toothed belt drive; Removing and installing  
toothed belt  
4. Descriptions of work  
191  
Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤  
Maintenance - Edition 11.2020  
4.71  
Spark plugs: renewing  
Renewing spark plugs, 1.4 l TSI engines ⇒ page 192  
Spark plugs: renewing, 1.4 l TSI engine (engine code CZEA) ⇒  
page 195  
Renewing spark plugs, 1.5 l TSI engines ⇒ page 199  
Spark plugs: renewing, 1.8 l TSI and 2.0 l TSI engines ⇒ page  
202  
Renewing spark plugs, 2.0 l TSI engine (engine code DNFA) ⇒  
page 204  
Special tools and workshop equipment required  
♦ Tapered roller bearing puller -T10530-  
♦ Spark plug socket -3122 B-  
♦ Torque wrench  
4.71.1  
Spark plugs: renewing, 1.4 l TSI en‐  
gines  
Removing  
– Loosen hose clips -1- and -2-, and remove air pipe.  
192  
4. Descriptions of work  
 

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!