Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
Inspection service interval display: resetting
With function button on dash panel insert
– With ignition switched off, press and hold button -1-.
– Switch on ignition.
Wait until “Reset inspection?” appears on the display. on the
display.
– Release button -1-.
The service interval display is now in the resetting mode.
– Briefly press button -1- once.
After a short time the display switches back to the original dis‐
play.
4.60
Service interval display: recoding
Note
If the display is not as shown in the procedure: ⇒ Operating
instructions for vehicle diagnostic tester
Recoding from flexible to fixed intervals
ODIS Service
– Connect vehicle diagnostic tester ⇒ page 30 .
– Switch on ignition.
– Carry out identification of vehicle.
– Enter task data, or select “Without task”.
– Select “Control units”.
– Select “Dash panel insert”.
– Select “Guided Functions”.
– Select “Change flexible/fixed intervals”.
– Carry out adaptation according to the information of “Guided functions”.
Changing values for maximum distance to be driven (km) until
next oil change service (fixed) during delivery inspection
ODIS Service
– Connect vehicle diagnostic tester ⇒ page 30 .
– Switch on ignition.
– Carry out identification of vehicle.
186
4. Descriptions of work
Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
ODIS Service
– Enter task data, or select “Without task”.
– Select “Control units”.
– Select “Dash panel insert”.
– Select “Guided Functions”.
– Select “Oil change service (fixed)”.
– Follow instructions in “Guided functions” mode.
– Reset “-1- Oil change service (fixed)”.
– Follow instructions in “Guided functions” mode.
The current values for maximum distance to be driven (km) until next oil change service are shown in the
display of the vehicle diagnostic tester.
– Select “No”.
– Select value for maximum distance to be driven until next oil change service, according to specifications
valid in your country.
– Carry out adaptation according to the information of “Guided functions”.
4.61
Track rods: checking clearance, at‐
tachment and boots
Sequence of operations
– Check play by moving track rods and wheels with the vehi‐
cle raised (wheels hanging free). Clearance (specified): no
clearance:
– Check that boots -arrow- are not damaged and are seated
correctly.
– Make sure that boots -1- of steering rack are not damaged
and are seated correctly.
4. Descriptions of work
187
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
