CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Screw in new securing bolts -arrows-.
Further assembly is basically a reverse of the dismantling se‐
quence.
Specified torques
♦ ⇒ “1.1 Assembly overview - poly V-belt drive”, page 37
1.8
Renewing oil seal for vibration damper
Special tools and workshop equipment required
♦ Thrust piece - T10354-
♦ Thrust plate - T10375-
♦ Flange nut - 10531/4- from assembly tool - T10531-
58
Rep. gr.13 - Crankshaft group
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
♦ Extractor hook - T40274-
Removing
– Remove vibration damper ⇒ page 51 .
•
Clamping pin - T10531/2- is inserted.
– Using extractor hook - T40274- , pull out seal -arrow-.
Installing
– Clean contact surface and sealing surface.
– Slide seal -arrow- onto thrust piece - T10354- .
•
Closed side of oil seal faces towards thrust piece - T10354- .
– Slide seal -arrow- with thrust piece - T10354- onto clamping
pin - T10531/2- , and fit it to lower timing chain cover.
1. Cylinder block (pulley end)
59
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– In addition, fit thrust pad - T10375- , and screw on flange nut
- 10531/4- .
– Using open-end spanner, AF 21, tighten flange nut until seal
has been pressed in as far as stop.
Note
♦ Renew bolt for vibration damper.
♦ Renew O-ring.
Further assembly is basically a reverse of the dismantling se‐
quence. During this procedure, observe the following:
– Install vibration damper ⇒ page 51 .
60
Rep. gr.13 - Crankshaft group
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
