Download
Table of Contents > Turbocharging/supercharging > Exhaust turbocharger > Removing and installing vacuum unit for turbocharger

VW Passat B6 Service Manual ➜ Removing and installing vacuum unit for turbocharger

CC 2010 ➀ , Eos 2006 ➀ , Golf 2004 ➀ , Golf 2009 ➀ , Passat 2006 ➀ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
– Secure locking plate -1- above linkage on turbocharger.  
1.6  
Removing and installing vacuum unit for  
turbocharger  
Removing:  
– Remove turbocharger β‡’ page 432 .  
Engine code BZB, CGYA, CDAA, CDAB:  
– Detach locking plate above turbocharger linkage.  
– Loosen lock nut -2-.  
– Separate rod from turbocharger -3-.  
– Remove vacuum unit -1- from turbocharger -arrows-.  
Engine codes CAWA, CAWB, CBFA, CCTA, CCTB, CCZA,  
CCZB, CCZC, CCZD:  
– Pull securing clip off vacuum unit linkage.  
1. Exhaust turbocharger  
443  
CC 2010 ➀ , Eos 2006 ➀ , Golf 2004 ➀ , Golf 2009 ➀ , Passat 2006 ➀ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
– Remove vacuum unit -1- from turbocharger -arrows-.  
Installing:  
Installation is carried out in the reverse order. When installing,  
note the following:  
Engine code BZB, CGYA, CDAA, CDAB:  
– Adjust vacuum unit β‡’ page 439 .  
Specified torques  
Component  
Nm  
10  
Vacuum unit to turbocharger  
444  
Rep. gr.21 - Turbocharging/supercharging  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!