CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
Tightening sequence on bracket for ancillaries
– Fit ancillary bracket (start bolt -4- first).
– Tighten bolts in sequence -1 … 5- in 3 stages as follows:
1.
2.
3.
Tighten bolts by hand.
Tighten bolts to 20 Nm.
1
Turn bolts 90° ( / turn) further.
4
1.2
Removing and installing poly-V belt
Removing
Caution
Danger of destruction due to reverse running direction in the
case of a poly V-belt that has already run.
♦ Before removing the poly V-belt, use a piece of chalk or a
felt pen to mark the running direction.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation .
– Remove right air hose -arrows-.
1. Cylinder block (pulley end)
39
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Turn tensioner in direction of -arrow- to relieve tension on poly
V-belt.
– Use the locking pin - T10060 A- to lock the tensioner.
– Remove poly V-belt.
Installing
Install in reverse order of removal, observing the following.
Note
Tighten alternator and air conditioner compressor mountings be‐
fore fitting poly V-belt.
– Fit poly V-belt onto crankshaft pulley first, then onto air condi‐
tioner compressor and alternator.
– Turn tensioner slightly with ring spanner and remove locking
pin - T10060 A- .
– Release tensioner.
– Check that poly V-belt is properly seated.
– Start engine and check that poly V-belt runs properly.
1.3
Removing and installing tensioner for poly V-belt (Passat 2006 ▶, CC)
40
Rep. gr.13 - Crankshaft group
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
