Download

Table of Contents > Lubrication > Oil filter, engine oil cooler and oil pressure switch (engine codes CCZA, CCZB, CCZC, CCZD, CDAA, CDAB) > Removing and installing oil pressure switch for reduced oil pressure F378

VW Passat B6 Service Manual ➜ Removing and installing oil pressure switch for reduced oil pressure F378

CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...

4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018

Removing

– Only vehicles with sound generator: Open catch -1-, unclip fuel

lines -2- and loosen bolt -3- on activated charcoal filter. Place

charge air pipe to one side.

– Pull off breather line -1-, release activated charcoal filter -A-

and remove upwards -B-. Place activated charcoal filter to one

side.

Note

Place a cloth underneath bracket for ancillaries to catch any es‐

caping oil.

– Separate electrical connector -4- on oil pressure switch - F1- .

– Unscrew oil pressure switch -3-.

Installing

•

Specified torque ⇒ page 229 .

Install in reverse order of removal, observing the following.

♦ Renew the seal.

♦ Insert new oil pressure switch immediately in hole to avoid loss

of oil.

♦ Check oil level.

4.4

Removing and installing oil pressure

switch for reduced oil pressure - F378-

Special tools and workshop equipment required

♦ Jointed wrench 24 mm - T40175-

232

Rep. gr.17 - Lubrication

CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...

4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018

Removing

– Only vehicles with sound generator: Open catch -1-, unclip fuel

lines -2- and loosen bolt -3- on activated charcoal filter. Place

charge air pipe to one side.

– Pull off breather line -1-, release activated charcoal filter -A-

and remove upwards -B-. Place activated charcoal filter to one

side.

Note

Place a cloth underneath bracket for ancillaries to catch any es‐

caping oil.

– Separate electrical connector -2- on oil pressure switch for re‐

duced oil pressure - F378- .

– Unscrew oil pressure switch for reduced oil pressure - F378-

-1-.

Installing

•

Specified torque ⇒ page 229 .

Install in reverse order of removal, observing the following.

♦ Renew the seal.

♦ Insert new oil pressure switch immediately in hole to avoid loss

of oil.

♦ Check oil level.

4.5

Checking oil pressure and oil pressure switch

4. Oil filter, engine oil cooler and oil pressure switch (engine codes CCZA, CCZB, CCZC, CCZD, CDAA, CDAB)

233

reload full screen

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.

Ask your question on the page - Support!

ALL VW Passat OWNER'S MANUALS

2024 VW Passat Owner's Manual