CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
13 - Bolt
❑ Tightening sequence ⇒ page 39
3.2
Removing and installing engine oil cool‐
er
Special tools and workshop equipment required
♦ Drip tray for workshop hoist - VAS 6208-
Removing
Proceed as follows:
WARNING
The cooling system is under pressure when the engine is hot!
Danger of scalding by steam and hot coolant.
Cover filler cap on expansion tank with a cloth and open care‐
fully to release pressure.
– Drain coolant ⇒ page 241 .
– Remove bracket for ancillaries ⇒ page 50 .
– Unscrew bolts -4 and 5- and remove engine oil cooler -3- to‐
gether with seal -2-.
Installing
Installation is carried out in the reverse order. When installing,
note the following:
•
Specified torques ⇒ page 225
Note
♦ Renew gaskets and seals.
♦ Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ EKTA (Electronic parts cata‐
logue) .
226
Rep. gr.17 - Lubrication
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Install engine oil cooler -3- with new seal -2-.
3.3
Checking oil pressure and oil pressure switch
Special tools and workshop
equipment required
♦ Oil pressure tester - V.A.G 1342-
♦ Voltage tester - V.A.G 1527B-
♦ Adapter set - V.A.G 1594C-
♦ Jointed wrench 24 mm - T40175-
3. Oil filter, engine oil cooler and oil pressure switch (engine codes CAWA, CAWB, CBFA, CCTA, CCTB, BZB, CGYA)
227
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
