CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
Chain sprocket - tightening sequence
Caution
The intermediate shaft sprocket must be replaced. Otherwise
no tooth backlash is set - engine damage. The new intermedi‐
ate shaft sprocket is coated with a solid film lubricant that wears
off after a short period and thus automatically sets the tooth
backlash.
– Tighten bolt as follows:
1.
2.
Pre-tighten to 10 Nm using torque wrench.
Turn sprocket.
Chain sprocket must be without play; otherwise loosen bolt and
tighten again.
3.
4.
Tighten to 30 Nm using torque wrench.
Use fixed wrench to turn 90° further.
1.10
Removing and installing drive chain for
balance shaft
The procedure “Removing and installing drive chain for balance
shaft” is part of the procedure “Removing and installing camshaft
timing chain” ⇒ page 114 .
1.11
Removing and installing inlet side bal‐
ance shaft
Special tools and workshop equipment required
♦ Puller - T10394-
♦ Puller - T10055-
1. Chain drive
129
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
