CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
2.11
Removing and installing continued cool‐
ant circulation pump - V51-
Special tools and workshop equipment required
♦ Hose clamps to 25 mm - 3094-
♦ Spring-type clip pliers - VAS 6362-
Removing
Proceed as follows:
WARNING
The cooling system is under pressure when the engine is hot!
Danger of scalding by steam and hot coolant.
Cover filler cap on expansion tank with a cloth and open care‐
fully to release pressure.
– Open filler cap on expansion tank.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation .
268
Rep. gr.19 - Cooling
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
– Disconnect electrical connector -1- for continued circulation
coolant pump - V51- .
– Place drip tray - VAS 6208- beneath engine.
– Clamp off coolant hoses -arrows- with hose clamps - 3094- .
– Disconnect coolant hoses from continued coolant circulation
pump - V51- .
– Remove bolt -2- and detach continued coolant circulation
pump - V51- .
Installing
•
Specified torques ⇒ page 267 .
Install in reverse order of removal, observing the following.
– Check coolant level.
2. Coolant pump, thermostat, coolant pipes
269
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
