CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018
1.2
Removing and installing camshaft con‐
trol valve 1 - N205-
– If fitted, remove charge air duct to sound generator
⇒ page 455 .
– Detach connector from inlet camshaft control valve 1 - N205-
-1-.
– Unscrew bolts -arrows- and remove inlet camshaft control
valve 1 - N205- .
Installing
•
Specified torque ⇒ page 88
Install in reverse order of removal, observing the following.
– Lubricate seal and O-ring with engine oil.
1.3
Removing and installing upper timing
chain cover
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1783-
♦ Open-end spanner insert AF 10 - V.A.G 1783/1-
Removing
– Remove engine cover panel ⇒ page 141 .
– Only vehicles with sound generator: Open catch -1-, unclip fuel
lines -2- and loosen bolt -3- on activated charcoal filter. Place
charge air pipe to one side.
Vehicles with activated charcoal filter in engine compartment:
1. Chain drive
91
2024 VW Passat Owner's Manual
VW Passat B7 Service & Repair Manual
VW Passat B6 Service & Repair Manual
