Download
Table of Contents > Mixture preparation - injection > Injection system > Removing and installing air filter housing

VW Passat B6 Service Manual ➜ Removing and installing air filter housing

CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
12 - Water drain hose  
❑ Clean water drain hose  
13 - Flutter valve  
14 - Intake air guide  
❑ To lock carrier.  
❑ Clean any leaves and dirt out of intake air duct  
2.4  
Removing and installing air filter hous‐  
ing  
Removing:  
Proceed as follows:  
– Pull cover off air duct (release clips on sides) -arrows-.  
– Release clips -arrows- air duct at the bottom and remove duct.  
– Detach air duct at bottom together with air hose.  
Engine code CBFA:  
– Pull hose to secondary air pump motor - V101- from air filter  
housing.  
All:  
– Pull off connector -1- from air mass meter - G70- .  
– Remove hose clips -2- and -3- and remove connecting pipe.  
– Remove bolt -4- and pull air filter housing upwards out of  
mounting.  
Installing:  
Install in reverse order of removal.  
2. Injection system  
467  
CC 2010 ➤ , Eos 2006 ➤ , Golf 2004 ➤ , Golf 2009 ➤ , Passat 2006 ➤ , ...  
4-cyl. injection engine (1.8 and 2.0 l engine, chain drive) - Edition 08.2018  
2.5  
Removing and installing air filter ele‐  
ment  
Removing  
Engine code CBFA:  
– Pull hose to secondary air pump motor - V101- from air filter  
housing.  
All:  
– Remove bolts -arrows- from upper part of air filter.  
– Lift up upper part of air filter and remove air filter element.  
Installing  
Specified torques: ⇒ page 466  
Note  
Always use genuine part for air filter element.  
Hose connections and hoses for charge air system must be  
free of oil and grease before assembly. Do not use lubricants  
containing silicone.  
The air filter housing must be clean.  
Secure all hose connections with the correct type of hose clips  
(same as original equipment): ⇒ ETKA (Electronic parts cata‐  
logue)  
To prevent malfunctions, cover all critical engine air ducting  
components such as air mass meter, intake pipes, etc. with a  
clean cloth when blowing out the air filter housing with com‐  
pressed air.  
Please observe disposal instructions!  
– Check air mass meter and intake hose for salt residue, dirt and  
leaves (engine intake side).  
– Check for dirt in air intake hose from air duct.  
– Remove snow screen -1- and clean it.  
Note  
The snow screen is not installed in all vehicles.  
468  
Rep. gr.24 - Mixture preparation - injection  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Passat you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!